Water Tank & Drain Hose - INVENTOR P3F-WiFi25L Manual Del Propietário

7. WATER TANK & DRAIN HOSE
There are two ways to remove collected water. Before proceeding ensure that you have
switched off and unplugged the unit.
1. Usage of the water tank
When unit is OFF and the tank of the dehumidifier is full, the full indicator will be lit and the
display will read P2. Additionally, when the unit is on and the tank is full, the compressor
stops operation followed by the fan a few minutes later. The full indicator will flash and the
display will show P2.
• Slowly remove the bucket. Grip the handle with caution and carefully pull outwards so
the water does not overflow. Do not place the tank on the floor because the bottom of the
tank is uneven. Doing so the tank will fall and the water will be spilled on the floor.
• Empty the water from the tank and place it again in to the device. The water tank, must be
securely and properly placed, for the dehumidifier to operate.
• When the water tank is re-installed the unit will automatically restart.
2. Continuous draining
Water automatically can be emptied into a floor drain
by attaching the unit with a water hose.
• Remove the plastic plug opposite the unit. Insert the
water hose into the outlet. All connections should be
firmly tight for possible leaks to be avoided.
• The dehumidifier should be placed on a flat surface
in an upright position.
• Lead the water hose towards a suitable drainage
facility and be certain that the water flows naturally.
For correct drainage, make sure the hose stays below
the level of the drain hose outlet.
12
• When you remove the tank, do not touch any parts
inside the unit, as you may damage the device.
• Be sure to gently place the tank into the dehumidifier.
• Do not drink or use the collected water from the device.
• Wipe any excess water on, or in, the unit when removing
the tank.
water drain hose
outlet
EN