Breakdown - Detection And Solutions - SPIDO SPR 500 Manual De Instrucciones

Breakdown – detection and solutions
Pump does not start?
Have you checked...
 If pump is connected to the mains?
 If there is no current failure of the mains?
You might need to...
 Check the mains
Low flow?
Have you checked...
 If connectors of the suction part are perfectly airtight?
 If the filter of the pump is not obstructed?
You might need to...
 Repair connections and/or change the suction hose
 Clean up the filter of the pump.
Pump does not prime ?
Have you checked...
 Connections airtightness?
 If pump positionning is in accordance with instructions (max 1m
above water level)?
 If the filter of the pump is not obstructed
 If the pump is full of water?
 If power supply is correct?
You might need to...
 Repair connections and/or change the suction hose.
 Place
(recommended heights of suction and discharge).
 Clean up the filter of the pump.
 Fill the pump with water.
Abnormal noise?
Have you checked...
 If the pump is correctly fixed on its support?
 If the pump did not suck up dirt?
the pump in accordance with its performances
GB