peerless-AV ESA763PU Instalación Y Montaje página 14

Adjustment of Flat Panel Display
• M10 x 15mm screws (E) must be securly tightened before changing orientation of wall arm assembly (A). Failure to
lock adapter bracket can cause display to come off of mount.
FOR PORTRAIT OR LANDSCAPE DISPLAY ORIENTATION: Remove two M5 x 12mm screws, one M5 x 6mm
6
screw and rotation block from top of tilt head as shown in top view and rear view. Gently grasp sides of display and
rotate display into portrait or landscape position as shown in fi gure 6.1 and reinstall rotation block with two
M5 x 12mm screws and one M5 x 6mm screw. NOTE: M5 x 6mm screw required in landscape orientation only.
TILT Adjustment: Adjust tension knob on side of
7
mount to desired tension to enable tilt adjustment
and balance your display size and weight. Push
or pull from top or bottom of display to adjust tilt
as shown. The tilt can be adjusted to a maximum
of 10° forward or 5° backward. Retighten tension
knob.NOTE: For larger displays, tension screw on
opposite side of mount may need to be tightened
using 5/32" allen wrench (L).
ROLL Adjustment: Rotate display 5° clockwise or
counter-clockwise, level display then tighten
M5 x 10mm roll screws using 5mm allen wrench (I)
as shown in detail 2.
FOR VERTICAL HEIGHT ADJUSTMENT: Tighten
or loosen M8 x 40mm screw to achieve ± 1" of
vertical height adjustment as shown in detail 2.
CAUTION
• Do not tighten screws with excessive force.
• Be careful not to pinch fi ngers when opening and
closing mount from the wall.
WARNING
ROTATION BLOCK
M5 X 6MM SCREWS
M5 X 12MM SCREWS
TOP VIEW
M5 X 6MM
SCREWS
ROTATION BLOCK
REAR VIEW
14 of 50
M5 X 12MM
SCREWS
fi g. 6.1
TENSION KNOB
M5 X 10MM
SCREWS
M8 X 40MM
SCREW
ISSUED: 01-05-11 SHEET #: 061-9062-7 03-22-12
DETAIL 2