Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Optional Horizontal Adjustment of Wall Arm on Wall Plate
NOTE: If mounting wall arm (A) to wood stud walls, slots on wall plate must align to wood studs.
1
Determine desired location of display center detailed in step 2.
Measure the distance from the center of wall arm (A) to desired display center. Loosen four 1/4-20 x 17mm screws
using 5mm allen wrench (I). Slide wall arm assembly 4-1/2" to the left or right as shown in fi gure 1.1. NOTE: Align
bevels (dots) of slide plate with bevels (dots) of wall plate rails as shown in detail 1 then retighten 1/4-20 x 17mm
screws.
Do not adjust arm while display is attached.
Skip to page 6 for Wood Stud Installation.
Skip to page 7 for Concrete and Cinder Block Installation.
1/4-20 X 17 MM SCREWS
WALL PLATE
WALL PLATE RAIL
SLIDE PLATE
DETAIL 1
WALL ARM
fi g. 1.1
5 of 50
ISSUED: 01-05-11 SHEET #: 061-9062-7 03-22-12
Publicidad
Tabla de contenido
