Lamborghini Caloreclima ECO 8 Manual Para La Instalación Y El Mantenimiento página 30

IGNITION ELECTRODES (4-5)
Clean the electrodes without varying their position with res-
pect to the diffuser; if you accidentally move them observe
the dimensions given in fig. 13 when re-assembling.
FUEL PUMP FILTER
Close the fuel aspiration gate, remove the pump cover, take
out the mesh cartridge, wash it with petrol and re-assemble
carefully.
PIPE FILTER
Close the fuel aspiration gate and, depending on the type,
proceed with thorough cleaning of the filtration component.
To check whether the air gate fan is clean or to check the
combustion head proceed as follows:
- Remove the cover (23) by loosening the screw (22).
- Loosen the lower screws (32) completely.
- Parzially loosen the upper screws (14) too.
- Release by raising the component support plate (34) and
hook it in its seat as illustrated in fig. 15.
Doing the above provides the conditions needed to check
whether the internal burner parts are clean and, where
necessary, to replace the motor-fan unit. When re-assem-
bling make sure that you observe the gap illustrated in
fig. 14.
WARNING: in the event of a dangerous situation cut power
by turning the main switch to OFF and stop fuel flow via the
relative gate.
- 30
-
Key
A 0,8 ÷ 1,3
B 3
C 5 ÷ 6
Fig. 13
Fig. 14
Fig. 15