Installation - Electrolux EUX2245AOX Manual De Instrucciones

12 www.electrolux.com
Problem
Temperature cannot be
set.
DEMO appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.
7.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.

8. INSTALLATION

8.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Possible cause
The FastFreeze or Shop‐
pingMode function is
switched on.
The appliance is in dem‐
onstration mode.
The temperature regula‐
tor is not set correctly.
The food products' tem‐
perature is too high.
The door has been
opened often.
The FastFreeze function
is switched on.
There is no cold air circu‐
lation in the appliance.
7.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
3. If necessary, replace the defective
Climate
class
SN
Solution
Switch off FastFreeze or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "Fast‐
Freeze or ShoppingMode
function".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Set a higher/lower tempera‐
ture.
Let the food products tem‐
perature decrease to room
temperature before storage.
Open the door only if neces‐
sary.
Refer to "FastFreeze func‐
tion".
Make sure that there is cold
air circulation in the appli‐
ance.
to "Installation".
door gaskets. Contact the Authorised
Service Centre.
Ambient temperature
+10°C to + 32°C