Troubleshooting - Franke FDW 614 D10P A+++ Manual De Usuario

TROUBLESHOOTING

Your dishwasher may not work properly.
Before contacting the Service Centre check if the problem can be solved by going through the following list.
PROBLEMS POSSIBLE CAUSES
The dishwasher The appliance has not been plugged in
won't start or does properly.
not respond to
commands.
Power outage.
The dishwasher door is not closed.
It does not respond to commands.
The dishwasher The wash cycle has not finished yet.
won't drain.
The drain hose is bent.
The sink drain pipe is blocked.
The filter is clogged up with food residues
The dishwasher The dishes are rattling against each.
makes excessive
noise.
An excessive amount of foam has been
produced.
The dishes are not The crockery has not been arranged properly. Arrange the crockery correctly (see LOADING THE RACKS).
clean.
The spray arms cannot rotate freely, being
hindered by the dishes.
The wash cycle is too gentle.
An excessive amount of foam has been
produced.
The cap on the rinse aid compartment has
not been shut correctly.
The filter is soiled or clogged.
There is no salt.
TECHNICAL DATASHEET
The technical data can be downloaded from the website:
www.franke.com
10
27-Apr-2019 06:34:30 EDT | RELEASED
SOLUTIONS
Properly insert the plug into the socket
The dishwasher starts automatically when the power returns.
Vigorously push the door until you hear the "click".
Switch off the appliance by pressing the ON/OFF button, switch it back on
after approximately one minute and reset the program.
Wait until the wash cycle finishes.
Check that the drain hose is not bent (see INSTALATION INSTRUCTION).
Clean the sink drain pipe.
Clean the filter (see CLEANING THE FILTER ASSEMBLY).
Arrange the crockery correctly (see LOADING THE RACKS).
The detergent has not been measured out correctly or it is not suitable for
use in dishwashers (see FILLING THE DETERGENT DISPENSER). Reset the cur-
rent cycle by switching OFF the dishwasher, then switch it on again, select a
new program and close the door. Please do not add any detergent.
Arrange the crockery correctly (see LOADING THE RACKS).
Select an appropriate wash cycle (see PROGRAMS TABLE).
The detergent has not been measured out correctly or it is not suitable for
use in dishwashers (see FILLING THE DETERGENT DISPENSER).
Make sure the cap of the rinse aid dispenser is closed.
Clean the filter assembly (see CARE AND MAINTENANCE).
Fill the salt reservoir (see FILLING THE SALT RESERVOIR).
CONTACTING AFTER-SALES SERVICE
When you contact the After-Sales Service,
you must provide the codes shown on
the rating plate attached to the left or
right side inside the door of the
dishwasher. The phone number is listed
in the warranty booklet or on the website:
www.franke.com
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
FDW 614 D7P A++ 61530110100 S/N xxxxxxxxx
117.0496.323
MADE IN POLAND 61530110100
IEC 436
220-240 V~50 Hz 0,05 ÷ 1 MPa 4
Max.1900W 1800 W TYPE: DWL-DEA701-B