Operating Instructions - Avanti STW16D0W Manual De Instrucciones

PRESS THE POWER BUTTON.
PRESS THE WATER LEVEL BUTTON.
Choose appropriate water level according to wash load quantity.
WATER TEMPERATURE CHOICE.
Press the water temperature selection button, you can choose from cold, warm, and/or hot water.
NOTE: The washer will provide a cold rinse in all TEMPERATURE settings.
Indicator
Light Shown
When the "COLD" indicator light is ON, it means the washing machine will only use
COLD
water supplied by the cold water inlet.
When the "HOT" indicator light is ON, it means the washing machine will only use
HOT
water supplied by the hot water inlet
When the "WARM" indicator light is ON, it means the washing machine will use water
WARM
supplied by both the cold and hot water inlets
IMPORTANT: A single cold hose system does not allow the washing machine to automatically
(select) regulate incoming water temperatures to match those listed on the control panel such as
WARM or HOT.
PRESS THE FUNCTIONS SELECTION BUTTON.
Choose the desired function and then the corresponding indicator blink.
PRESS DOWN START/PAUSE BUTTON ONCE AND THE MACHINE WILL BEGIN OPERATION.
Please press this button to stop the normal operation, if it continues to work, press it again.
Water level can be reset during the normal operation. If the higher water level is selected, the machine
will operate after refilling the water level selected.
MANUAL FUNCTIONS SELECTION (CUSTOM WASHING CYCLE)
WASH ONLY

Press down the power button.

Press the Function button until only the WASH indicator is ON.

Press the water temp button to select the water temperature.

Press the water level button to select the appropriate water level setting.

Press the START/PAUSE to start the course. And the LED display will show the remaining time of
the entire course.
WASH AND RINSE

Press down the power button.

Press the Function button until the WASH & RINSE indicators are ON.

Press the water temp button to select the water temperature.

Press the water level button to select the appropriate water level setting.

Press the START/PAUSE to start the course. And the LED display will show the remaining time of
the entire course.
RINSE AND SPIN

Press down the POWER button.

Press the Function button until the RINSE & SPIN indicators are ON.

Press the water level button to select the appropriate water level setting.

Press the START/PAUSE to start the course. And the LED display will show the remaining time of
the entire course.

OPERATING INSTRUCTIONS

Description
15