Installing The Noise Damper Plate; Connecting The Water Supply Hoses / Sink Faucet Connection - Avanti STW16D0W Manual De Instrucciones

INSTALLING THE NOISE DAMPER PLATE

Affix the noise proof plate by using the screws.
CONNECTING THE WATER SUPPLY HOSES
The water supply hose must be connected to the washing machine at one end and to the water faucet
at the other. Do not stretch the water supply hose. If the hose is too short and you do not wish to
move the water faucet, replace the hose with a longer, high-pressure hose.
Select appropriate faucet as shown in the figures below. If none of these faucets are available, use
the faucet adapter provided.
The end of faucet spout should be longer than 10mm (0.4"), or the connector cannot be fixed properly.
Water leakage could develop.
1. Connect the water inlet hose to the
faucet by turning the connecting nut.
Rubber ring seal
CONNECTING
Be sure a rubber ring is inside the connecting nut.
If you have both cold and hot water supplied, connect the inlet hoses by matching cold to cold and hot
1. Connect the water inlet hoses to the faucets
by turning the connecting nuts.
CONNECTING
NUT
WATER INLET HOSE
Be sure the rubber rings are inside the connecting nuts.
2. Then connect the other end of water
inlet hose to the cold connector in
water mixing valve by turning the
connecting nut.
CONNECTING
NUT
NUT
WATER
INLET HOSE
2. Unscrew the lid of hot water connector
in water mixing valve, and then connect
the other end of water inlet hoses to the
connectors in water mixing valve by
turning the connecting nuts.
CONNECTING
NUT
WATER
INLET HOSE
CONNECTING
NUT
9
LID OF
HOT WATER
CONNECTOR
COLD WATER
CONNECTOR
to hot.
HOT WATER
CONNECTOR
COLD WATER
CONNECTOR