Tristar KB-7146 Manual De Usuario página 5

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30
• When the battery used is a car battery, only switch the cool box on
while the car is traveling. If the cool box is left running when the car is
stopped, this could discharge the battery and it may be impossible to
restart the engine.
• When the appliance is running on the battery, there is no thermostat-
controlled temperature regulation.
Recommendation
Pre-cool the cool box by running it on the mains, before starting the journey.
Start-up
Plug the connector supplied with the cool box into the cigar lighter socket
of the vehicle.
Disconnection of the appliance
Unplug the connector from the cigar lighter socket.
oPeRaTIoN wITh gaS
• Never use another source of energy at the same time (mains, battery).
• Operation of the cool box on gas is prohibited in road vehicles and on
boats. Operation using gas is prohibited in closed areas.
• This appliance must be in the open air when operating with gas.
• Operation in the open air means that the appliance can also be
installed under the canopy of a tent, sufficiently ventilated, or on a
terrace in a flat and level garden.
• The label at the rear of the appliance gives the recommended gas
supply pressure expressed in mbar. The appliance can't operate at a
pressure other than the one specified on the label.
Storage of gas cylinders
• Store the gas cylinder in a cool, dry and ventilated area, protected from
sunlight and do not exposed to temperatures above 50°C.
CoNNeCTIoN oF The Cool box To The
CYlINDeR oF lIqueFIeD PeTRoleuM gaS
CauTIoN: always stay clear of any source ignition during this operation.
Do not smoke. Connect the Coolbox in the following order: gas
cylinder > pressure regulator > appliance.
• The gas connection tube at the rear of the appliance is designed for a
standard NF XPD 36 110 butane / propane flexible hose. It is essential to
follow the assembly and connection instructions for the appliance to be
connected. Excessive twisting and bending are to be avoided. Bends in
the gas hose must have a radius of more than 40 mm. The length of the
hose must not exceed 1,50 m.
• If you wish to check for leaks, please use soapy water, do not use a flame.
• It is prohibited to check for leaks with a flame.
• Do not smoke: danger of explosion and burns.
• When changing the gas cylinder and/or disconnecting the hose, it is
mandatory to close the valve of the gas cylinder.
• Replace the hose if it is damaged or if it becomes porous and in any
case before the expiry date printed on the side.
Cool box
eN
5

Publicidad

Tabla de contenido
loading

Tabla de contenido