Tabla de contenido
Publicidad
20. Do not move the device when the inner tank is filled with water.
21. Do not place any objects on the device.
22. The device can be used only with properly working ventilation.
DEVICE DESCRIPTION
1. Air outlet opening
3. Wheels
5. Mesh filter
7. Water tank
USING THE DEVICE
1. Place the unit on a dry, flat surface and connect to the power supply.
2. Pul out the water tank (7) from the back of the machine and pour in the water (Fig.B). Be careful not to exceed the maximum level.
3. Turn on the device using the "ON " button (8) on the control panel.
4. The SPEED button on the control panel allows you to change the speed of the blower unit. The following speeds can be selected:
HIGH (fast), MIDDLE (medium) and LOW (slow).
5. COOL button lowers the temperature of the air by running the water pump. Additionally, a set of two cartridges is attached.
To use them, put them on 24hours inside the freezer. Then add one or both of the water tank (7). To blow cool air, the device must be
filled with water. When the device is operating, periodically check the water level to see whether to add water.
6. Pressing the SWING button starts the oscillation of vertical slats that provide even distribution of cold air stream. Horizontal slats do
not move automatically, so if necessary, manually adjust them to point up or down.
7. The TIMER button allows for programming the amount of time during which the device will operate before turning itself off
automatically (if the TIMER function is not used, the device will work until it is manually turned off).
8. The MODE button allows for changing the fan mode. In addition to the normal mode, you can select "NATURE" and "SLEEP." The
NATURE mode mimics the natural wind action by changing the fan speed about every 10 seconds and changing the speed from LOW
through MIDDLE to HIGH. The SLEEP mode makes the device turn itself off after a specified period of time. If the speed is set to LOW,
the device will turn off automatically after 30 minutes. If the speed is set to MIDDLE, after 30 minutes the device will reduce the speed to
LOW and after another 30 minutes will turn off automatically. If the speed is set to HIGH, the device after 30 minutes, reduce the speed
of the MIDDLE, then after another 30 minutes, reduce the speed to LOW and after another 30 minutes, turn off automatically.
Same operation for remote control
CLEANING AND MAINTENANCE
1. Clean with soft, dry cloth. Do not use chemical solvents because they can cause permanent damage or deformation of the device.
2. If the device is not used for three or more months, take the batteries out of the remote control.
TECHNICAL DATA:
Power source:
220-240 V ~50/60 Hz
Power:
60W
Powe Max:
300W
Tank capacity:
7L
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste
bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may
effect the environment. Do not dispose this appliance in the common waste bin.
LESEN SIE AUFMERKSAM WICHTIGE ANWEISUNGEN BEZÜGLICH DER SICHERHEIT
DER BENUTZUNG BEWAHREN SIE DIESE FÜR DIE ZUKUNFT AUF
Bei Verwendung des Gerätes zu gewerblichen Zwecken werden die Garantiebedingungen
geändert.
1. Vor dem ersten Gebrauch, die Bedienungsanleitung lesen und die dort angegebenen
Hinweise beachten. Der Produzent trägt keine Verantwortung für Schäden, die aufgrund
von bestimmungswidriger Nutzung oder unsachgemäßer Bedienung entstanden sind.
2. Das Gerät ausschließlich an die Steckdose 220-240 V - 50/60 Hz anschließen. Es darf
nicht zu anderen, bestimmungswidrigen Zwecken benutzt werden.
3. Wegen Vorsichtsmaßnahmen, sollten keine weiteren Geräte an den gleichen Stromkreis
angeschlossen werden.
4. Falls sich Kinder in der Nähe befinden, sollte bei der Nutzung des Gerätes spezielle
Vorsicht bewahrt werden. Dieses Gerät ist nicht zum Spielen für Kinder, sowie für
2. Water level indicator
4. Carrying handle (on both sides)
6. Power cord holders
8. Control panel
ALLGEMEINE SICHERHEITSVORSCHRIFTEN
Device is made in class I of insulation and has to be connected
only to power outlet with ground circuit.
Device is compliant with EU directives:
Low voltage directive (LVD)
Electromagnetic compatibility (EMC)
Device marked CE mark on rating label
DEUTSCH
4
9.Remote control
Publicidad
Tabla de contenido
