Publicidad
Idiomas disponibles
Idiomas disponibles
UNPACKING
This product requires some assembly.
Carefully remove the product and any accessories from the box.
Make sure that all items listed in the packing list are included.
Inspect the product carefully to make sure no breakage or damage
occurred during shipping.
Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
If any parts are damaged or missing, please call 1-800-313-5111 for
assistance.
PACKING LIST
Pole Hedge Trimmer head
Grip Handle
Connecting Pole
Charger and Battery Pack
Blade Cover
Shoulder Strap
Owner's Manual
WARNING: Do not install battery until assembly is complete. Failure
to comply could result in accidental starting and possible serious
personal injury.
WARNING: If any parts are damaged or missing do not operate this
product until the parts are replaced. Failure to heed this warning
could result in serious personal injury.
TO ASSEMBLE THE POLE:
Align the locking pin on tube (B) with the hole (D) of the grip handle
(A).
Slide the tube into the grip handle. Ensure the locking pin clicks into
the hole.
Fasten swing nut (C) firmly.
Align the locking pin on trimmer head (E) with the hole of the
connecting tube (B).
Slide the trimmer head into the tube. Ensure the locking pin clicks
into the hole.
Fasten swing nut firmly.
Note: connecting tube and trimmer head can be installed one way
only. When necessary, you can connect trimmer head directly with
the grip handle.
ASSEMBLY
ATTACHING THE SHOULDER STRAP
Attach the shoulder strap to the strap bracket. Use the shoulder
strap to help support the trimmer while in use.
PIVOTING THE POWER HEAD
The Pole Hedge Trimmer is equipped with a power head
The power head has a spring-loaded button that allows it to be
locked into six positions within its 180-degree rotation. Before
starting the Pole Trimmer, make sure the power head is locked into
position. Do this by trying to rotate the power head in either
direction. The power head should be locked in position and should
not rotate. To pivot the power head, follow the instructions below.
1.
Push the round button (A) located on both sides of the pivot
bracket. The button is spring-loaded, so you will feel some
resistance.
2.
Grasp the power head motor housing and rotate the power
head to the preferred position.
3.
Release the round button. It should snap back into its seated
position. If it does not, rotate the power head back and forth
slightly until the button snaps back into its seated position. The
power head is now locked into position and ready for use.
BATTERY INSTALLATION AND REMOVAL
Hold the tool and the battery firmly when installing or
removing battery
Failure to hold the tool and the battery firmly may cause
them to slip from your hands and may result in damage to
the tool and/ or battery and a personal injury.
To remove:
Depress release button (A) on the back of battery
cartridge (B) to release the battery.
Pull the battery out of tool.
To install:
Align the battery with the cavity in
the handle.
Insert the battery into the handle
until the battery release button
locks into place. You should hear a
"click" once the battery is installed.
Note: The battery can only be
installed one way.
5
Model LPHT12022
th
at pivots.
Publicidad
