ROBLIN GLISS Manual De Instrucciones página 24

RECIRCULATION VERSION AIR OUTLET
• Insert the connection extension pieces laterally 14.1 in connec-
tion 15.
• Insert the Connector 15 into the Support bracket 7.3 and fix it
with 2 screws.
• Make sure that the outlet of the extension pieces 14.1 is hori-
zontally and vertically aligned with the chimney outlets.
• Connect the air outlet connection 15 to the hood body outlet
using either a flexible or rigid pipe ø 150 mm, the choice of
which is left to the installer.
• Ensure that the activated charcoal filters have been inserted.
ELECTRICAL CONNECTION
• Connect the hood to the mains through a two-pole switch hav-
ing a contact gap of at least 3 mm.
• Remove the grease filters (see paragraph Maintenance) being
sure that the connector of the feeding cable is correctly inserted
in the socket placed on the side of the fan.
• Fix the corner element 15 to the hood canopy using the screws
12d (2.9 x 9.5) provided.
Upper chimney
• Open the two side pieces out slightly, hook them up behind the
brackets 7.2.1 and bring them back together again until they
are in contact.
• Fix them to the sides of the Brackets using 4 Screws 12c (2.9 x
9.5) provided.
• Make sure that the outlet from the Connector extensions is in
correspondence with the Chimney openings.
Lower chimney
• Open out the two Chimney side flaps, hook them up between
the upper chimney and the wall and then close them up again
until they touch.
• Fix the lower part to the Hood canopy at the sides, using 2
screws 12c (2.9 x 9.5) provided.
EN
Fitting the Chimney
2
24