Attaching And Detaching For The Power Unit - Maruyama M42BK-QC Manual Del Propietário

Attaching and Detaching for the Power
Unit and the Shaft Assembly
Attaching
1 First, loosen the clamping knob before attaching
the shaft assembly to the shaft coupler.
Note : Do not over loosen the clamping knob or it
may fall out.
2 Insert the shaft assembly to the shaft coupler with
the positioning hole faced up as shown. Connect
the both drive shafts completely in the matching
position by moving the shaft assembly to forward
and backward and left turn and right turn. When
the shaft assembly is positioned correctly, spring
tensioned positioning lever will be returned to the
initial position.
3 Tighten the clamping knob firmly.
Shaft Coupler
Clamping Knob
Loosen
Incorrect Assembled
Positioning lever is
lowered state
Correct Assembled
Positioning lever is
raised state
Positioning Lever
Positioning Hole
Shaft Assembly
Tighten
Insert
Positioning
Lever
Detaching
1 First, loosen the clamping Knob before detaching
the shaft assembly to the shaft coupler.
2 Pull out the shaft assembly from the shaft coupler
while holding the positioning lever down.
3 Note : Do not over loosen the clamping knob or it
may fall out.
Clamping Knob
Loosen
— US-15 —
Positioning Lever
Push down
Shaft Assembly
Removal