Connecting Throttle Cable And Stop Switch Wires - Maruyama B420H Manual Del Propietario U Operador

ASSEMBLY INSTRUCTIONS
ENGINE AND SHAFT ASSEMBLY
Attach the clutch drum housing to the engine using the four screws.
HORN HANDLES
1. Loosen the four screws on the top of the clamp bracket.
2. Insert the left and right horn handles into the clamp bracket.
CONNECTING THROTTLE CABLE AND STOP SWITCH
WIRES
1. Insert the throttle cable through the cable adjuster sleeve.
2. Position the slotted fitting on the carburetor so the recessed hole
for the lug is away from the cable adjuster sleeve.
3. Rotate teh carburetor throttle cam and slip the throttle cable
through the slot in the slotted fitting, making sure the cable lug
drops into the recessed hole.
4. Operate the throttle trigger a few times to make sure that it works
correctly.
5. Adjust the cable adjuster sleeve so the stop on the carburetor throt-
tole cam just contacts the throttle stop and the cable position keep
1-2mm play between cable lug and slotted fittings when the throttle
trigger is fully depressed.
6. When the throttle cable is adjusted correctly, tighten the lock-nut.
7. Plug the stop switch wires into the matching connectors from the
engine.
Note: That wire polarity is not important.
8. Clamp the throttle cable assembly with two bands as shown.
DEBRIS SHIELD
Attach the debris shield to the shaft assembly with the two M6×30
screws.
— US-3 —
Engine
Clutch Drum Housing
Stop Switch Wires/
Throttle Cable
Handlebar
Clamp Bracket
Throttle Cable Housing
Cable Adjuster Sleeve
Lock Nut
Carburetor
Bracket
Slotted
Fitting
1-2mm Play
Stop Switch Wires
Band (2)
Screw
M6x30 (2)
Gearcase
Clamp
(Threaded)
Screw (4)
Screw (4)
Throttle Cable
Cable Lug
Recessed Hole
Throttle Cable
Shaft Assembly
Clamp
Debris Shield