Installation - Agio WT17ZL Instrucciones De Ensamblado

INSTALLATION

1. Carefully unpack all items from the box. Place the base in the final position. There must be
a minimum of 60.96 cm / 24 inches of clearance from the side of the table top to any
combustible walls.
2. Attach the top connector bracket to the firepit base frame by using four 1/4"x40mm bolts
and Ø6.5 X 1.0mm washers as shown in Figure 3. Hand tighten only.
Figure 3
3. Attach the bottom connector bracket to the firepit base frame by using four 1/4"x60mm bolts
and Ø6.5 X 1.0mm washers as shown in Figure 4. Hand tighten only.
Figure 4
4. Attach the top and bottom connector brackets to a table leg by using a 1/4"x40mm bolt and
1/4"x20mm bolt as shown in Figure 5. Add a Ø6.5 X 1.0mm washer to each bolt. Hand
tighten only. Repeat for the oppose side.
Figure 5
7