Agio WT17ZL Instrucciones De Ensamblado página 8

9 piezas juego de comedor alto y tejido con fogón
Ocultar thumbs Ver también para WT17ZL:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5. After making any necessary adjustments to the alignment of the connector brackets, table
legs, and the firepit base frame, use the hex bolt driver to tighten all bolts . Repeat until all
bolts are tight. Do not over tighten. Over tightening may strip bolts.
6. Place the tabletop onto the assembled firepit base. Secure the tabletop to the firepit base by
using four 1/4"x40mm bolts and Ø20xØ6.5x1.0mm washers as shown in Figure 6. Hand
tighten only.
7. Place the burner pan protective ring into the firepan/burner assembly as shown in Figure 3.
Align the holes in the burner pan protective ring with the pre-drilled holes on the firepan/burner
assembly. Secure the burner pan protective ring to the firepan/burner assembly by using the
two M4 screws as shown in Figure 7.
8. Pour the fire ice into the burner pan completely covering the burner. The weight of the fire
ice is (8kg plus and minus 10%).Remove any fire ice on top of the ignition well. See Figure8.
8
Figure 6
Figure 7
Figure 8

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Are018001900600

Tabla de contenido