Sony XAV-W651BT Manual De Instrucciones página 28

The other party says that the volume is too low
or high.
 Adjust the [MIC Gain] level (page 16).
Echo or noise occurs during call conversations.
 Reduce the volume.
 If ambient noise other than the phone call sound
is loud, try reducing this noise.
– Shut the window if road noise is loud.
– Lower the air conditioner if the air conditioner is
loud.
The phone sound quality is poor.
 Phone sound quality depends on reception
conditions of the cellular phone.
– Move your car to a place where you can
enhance the cellular phone's signal if the
reception is poor.
The volume of the connected BLUETOOTH device
is low or high.
 Volume level will differ depending on the
BLUETOOTH device.
– Reduce the volume level differences between
this unit and the BLUETOOTH device (page 13).
The sound skips during audio streaming or the
BLUETOOTH connection fails.
 Reduce the distance between the unit and the
BLUETOOTH device.
 If the BLUETOOTH device is stored in a case which
interrupts the signal, remove the case while
using the device.
 Several BLUETOOTH devices or other devices (e.g.
ham radio devices) which emit radio waves are
used nearby.
– Turn off the other devices.
– Increase the distance between the unit and
other devices.
 Playback sound stops momentarily when this
unit is connecting to a cellular phone. This is not
a malfunction.
You cannot control the connected BLUETOOTH
device during audio streaming.
 Check that the connected BLUETOOTH device
supports AVRCP.
Some functions do not work.
 Check that the connecting device supports the
functions in question.
A call is answered unintentionally.
 The connecting phone is set to start a call
automatically.
 [Auto Answer] of this unit is set to [ON] (page 16).
Pairing failed due to time out.
 Depending on the connecting device, the time
limit for pairing may be short. Try completing the
pairing within the time.
28
GB
The BLUETOOTH function cannot be operated.
 Turn the ignition off. Wait for a while, then turn
the ignition to the ACC position.
No sound is output from the car speakers during
a handsfree call.
 If the sound is output from the cellular phone, set
the cellular phone to output the sound from the
car speakers.
Siri Eyes Free is not activated.
 Perform the handsfree registration for an iPhone
that supports Siri Eyes Free.
 Set the Siri function on the iPhone to on.
 Cancel the BLUETOOTH connection with the
iPhone and the unit, and reconnect.
SongPal operation
Application name is mismatched with the actual
application in "SongPal."
 Launch the application again from the "SongPal"
application.
Pandora® operation
Pandora® connection is not possible.
 Shut down the Pandora® application on the
mobile device, then launch it again.
Error displays/messages
USB hub not supported
 USB hubs are not supported on this unit.
No Playable Data
 The disc does not contain playable data (XAV-
W651BT).
 The iPod has no playable data.
– Load music data/files into the iPod.
 The USB device has no playable data.
– Load music data/files into the USB device.
Cannot play this content.
 The currently selected content cannot be played
back.
– Playback content will be skipped to the next
one.
Overcurrent Caution on USB
 The USB device is overloaded.
– Disconnect the USB device, then change the
source by pressing the SOURCE button.
– Indicates that the USB device is out of order, or
an unsupported device is connected.
USB device not supported
 For details on the compatibility of your USB
device, visit the support site on the back cover.