Installation - Sony XAV-W651BT Manual De Instrucciones

Installation

Mounting the unit in the dashboard
When mounting in a Japanese car, see "Mounting
the unit in a Japanese car" (page 35).
Mounting the unit with an installation kit
(not supplied)
Before installing, make sure the catches on both
sides of the bracket are bent inwards 3.5 mm (
in).
1
Position the bracket inside the dashboard,
then bend the claws outward for a tight fit.
Bracket
2
Mount the unit onto the bracket.
Note
If the catches are straight or bent outwards, the unit will not
be installed securely and may spring out.
Larger than
Catch
182 mm (7 1
Larger than
111 mm (4 3 / in)
8
Bracket
Mounting the unit in a Japanese car
You may not be able to install this unit in some
Japanese cars. In such a case, consult your Sony
dealer.

5 /
32
Parts supplied with your
car
When mounting this unit to the preinstalled
brackets of your car, use the supplied screws  in
the appropriate screw holes based on your car: T
for TOYOTA, M for MITSUBISHI and N for NISSAN.
/ in)
4
Note
To prevent a malfunction, install only with the supplied
screws .
Resetting the unit
For details, see "Resetting the Unit" (page 7).
Fuse replacement
When replacing the fuse, be sure to
use one matching the amperage
rating stated on the original fuse. If
the fuse blows, check the power
connection and replace the fuse. If
the fuse blows again after
replacement, there may be an
internal malfunction. In such a case, consult your
nearest Sony dealer.
To the dashboard/center console
Bracket
Bracket

Fuse (10 A)
35
GB