General Information; Unpacking; Accessories Included; Assembly - Generac GP Serie El Manual Del Propietario

General Information

1.1 UNPACKING

1.1.1 ACCESSORIES INCLUDED

Feet (D), 2-Short Bolts (F)]

1.2 ASSEMBLY

The generator requires some assembly prior to using it. If
problems arise when assembling the generator, please call the
Generator Helpline at 1-888-436-3722.

1.2.1 ASSEMBLING THE ACCESSORY KIT

Refer to the instructions below and Figures 1, 2, and 3 to install the
handle, foot, and wheels. Note: The handle and foot components
are already pre-assembled from the factory. The wheels are
designed to greatly improve the portability of the generator. You
will need the following tools to properly install the accessory kit:
Handle
1. Install the handle assembly to the frame by using bolts (A) and
nuts (B).
Foot
2. Mount the foot assembly (E) to the frame with two bolts (F)
and nuts (C).
Wheels
3. Slide axle pin (G) through wheel (H), washer (I), and through
the bracket on the frame.
4. Secure axle pin (G) to the frame with the cotter pin (J).
4
5. Use a pliers and bend one tab of cotter pin (J) outward to lock
into place.
6. Repeat steps 4, 5, & 6 for other wheel.