Automatic defrost
Automatic defrost is started during the conservation phase and is regulated by the card set-up.
The defrosting process can be stopped manually by pressing the "up" key again for 4 seconds. When the
process is stopped, a signal blinks on the label display [ndF].
On the +14 °C / +16 °C units there is no automatic defrost.
Press this key
for 3 seconds and release it as the display shows the [Sby] to set the appliance to the
stand-by mode.
WARNING: the main switch
Set the general cut-out in OFF position.
To isolate the unit from electrical tension disconnect its plug from the outlet.
In case of working irregularities, before to call the technical service in zone verify that:
the main switch
the regulated temperature is the wished one;
that the door is perfectly closed;
the machine is not near heat sources;
the condenser is clean and the fan works regularly;
an excess of hoarfrost does not cover the evaporating pannel.
In case of negative result, contact the nearest service centre indicating the model and the serial number
shown on the rating placed on the appliance instrument panel.
To guarantee perfect hygiene and conservation of the unit it is well to carry out regular and/or daily cleaning
operations.
Avoid using abrasive creams or stainless steel wool pads, acetone, chlorylene or ammonia.
Use only a solution of water and bicarbonate.
Any food stains or residue on the outside surface should be removed with water before they harden.
If residues are already hardened used a sponge soaked in a solution of water and bicarbonate.
Daily cleaning of all inside surfaces of the appliance is recommended.
Clean the shelves and the interior of the unit with a lightly dampened cloth.
The space around and under the refrigerator must also be cleaned and held in perfect hygiene.
Clean using water and neutral soap or detergent.
DOES NOT insulate the machine from the electric current.
is lighting and the current is present;
WORKING IRREGULARITIES
18
STOPPING
DAILY CLEANING