General Cleaning And Maintenance - Sagi KP12Q Manual De Uso

For regular and constant service of the unit it would be well to regularly carry out general cleaning and
maintenance operations.
WARNING: The cleaning and mantainance of the refrigerating engine and the compressor area needs the
intervention of a skilled technician, therefore it cannot be done by other persons.
Clean the exterior and interior surfaces with soap or a neutral detergent and water: a little vinegar added to
the water will eliminate any eventual foul odours.
Before to begin with the operations proceed as following:
- set the general cut-out in OFF position;
- remove the plug from the socket and wait till the complete entfrosting of the unit.
To access the condenser it is necessary to remove the front dashboard:
1. Remove the lower instrument panel, grasping it on the side, freeing it from the four retaining bolts
2. Remove the cable from the panel control board
WARNING: to assure a regular use of the machine it is necessari to clean the copper-alluminium
condensator at least every 30 days.
Accurately clean the condenser in the refrigerating unit and the inner evaporator with either a vacuum
cleaner, a bristle brush or a non-wire brush after removing the protections.
Perform lubrication to ensure regular operation of the "soft motion" flapdoor opening system..
ATTENTION: the operations described must be carried out by specialised technical personnel.
- Remove the two front guards, unscrewing the fixing screws on the internal sides of the same; to complete
this operation the doors must be opened one at a time.
-
- Remove any traces of dust and/or dirt.

GENERAL CLEANING AND MAINTENANCE

19