GE GFW490 Manual Del Propietario E Instrucciones De Instalación página 18

Care and Cleaning.
Lock tab is visible only after
drawer has been pulled out
18
Dispenser Drawer Area: Detergent and fabric softener may build up in the dispenser
drawer. Residue should be removed once or twice a month.
Remove the drawer by first pulling it out until it stops. Then reach back into the left
rear corner of the drawer cavity and press down firmly on the lock tab,
pulling out the drawer.
Remove the insert from the bleach and fabric softener compartments and the
detergent cup. Rinse the inserts and the drawer with hot water to remove
traces of accumulated laundry products.
To clean the drawer opening, use a small brush to clean the recess.
Remove all residue from the upper and lower parts of the recess.
Return inserts to the proper compartments. Replace the dispenser drawer.
To reduce buildup in the Dispenser Drawer area:
Use only HE
High-Efficiency
detergent.
Cleaning the Door Gasket
Open the washer door. Using both hands, press down the door
gasket. Remove any foreign objects if found trapped inside the
gasket. Make sure there is nothing blocking the holes behind the
gasket.
While holding down the door gasket, inspect the interior gasket by
pulling it down with your fingers. Remove any foreign objects if found
trapped inside this gasket. Make sure there is nothing blocking the
holes behind the gasket.
When you are finished cleaning the door gasket, remove your hands
and the gaskets will return to the operating position.
Video
Scan this code
to watch a video
on this topic.