Operating Elements And Displays; Wifi Control; Rating Plate - CASO DESIGN WineComfort 1260 Smart Instrucciones De Funcionamiento Originales

14.1 Operating elements and displays

► Use the buttons
5-20°C.
► Temperature recommendations: Red wine: 12°C – 16°C and white wine 6°C – 10°C.
► When both - up and down zone - are working, the temperature of upper zone must be
lower than or equal to the temperature of down zone.
► In case of high temperature difference between both zones the energy consumption of the
device may be higher as indicated in the technical data.
If you press the power button of :
Upper zone -> the device is switched on
Down zone -> the down zone is switched on/off
When the LED lights the device is working.
With pushing both
exchange between °C and °F.
You can set the temperature as your desire: With
temperature by 1°C among 5-20°C.
You can tune the interior light on or off by pressing the "Light" button. The light will
switch off automatically after 4 hours to save energy.
The temperature in the device depends on the room temperature, the quantity of bottles and
the chosen temperature. Please note that your device is intended to cool wine. The
maximum temperature that can be reached inside the device cannot be significantly ABOVE
the ambient temperature at the setup location.

14.2 WiFi control

The device can optionally also be controlled / programmed via app via WiFi. Download the
CASO-App to your smartphone or tablet. Details about the app, the scope of operation and
installation instructions can be found on our website www.caso-germany.de

14.3 Rating plate

The rating plate with the connection and performance data can be founded on the back of
the device.
Please note
and to set the temperature for both zones in the range of
and for 5 seconds, the temperature display mode will be
and you can adjust the
35