Control Panel - Schumacher Electric SE-4020-CA Manual Del Usuario

9.1 Attach the foot: Remove the charger
from the packing materials
and place upside down
on a flat surface.
Attach the foot
and secure it with
the two 10-24 x 5/8"
thread cutting
screws provided.
9.2 Assemble the wheels and axle: Hold the
axle upright on the floor or work surface.
Then, using a hammer, tap one of the axle
caps onto the top end of the axle. Be sure
to tap the axle cap on straight. Slide both
wheels onto the axle with the recessed
hubs facing out as shown. Install the
second axle cap.

10. CONTROL PANEL

ON/OFF SWITCH
Use this switch to select between the
CHARGE/MAINTAIN rate, BOOST rate or
the ENGINE START mode.
• OFF – When the switch is in this position
(middle), the charger is turned off.
• BOOST or CHARGE/MAINTAIN –
When the switch is in this position, the
Rate Selection button can be set to either
the 6A<>2A Charging/Maintaining or the
40 amp Boost setting.
• ENGINE START – When the switch is in
this position, the Engine Start LED will
illuminate.
DIGITAL DISPLAY
The Digital Display gives a digital indication
of amperage or time. The display will
show the amperage when the charger is
charging a battery. During timer operation,
the display shows the remaining time.
When the charger goes into charging
mode, the display will automatically
change to ON (to show charging has
started). If you manually stop the charging
process (by pressing the Rate Selection
button) before the battery is fully charged,
the display will show OFF.
1
4
4
9.3 Mount the axle to the charger: Place
one end of each bracket into the slot on
the bottom of the charger. Place the axle
assembly under each bracket. Attach
the brackets, using the two 10-32 thread
cutting screws provided.
NOTE: Be careful not to drop the brackets
4
inside of the charger case.
9.4 Attach the handle: Turn the charger
right side up onto its foot and wheels.
Align the handle, so the screw holes
are aligned with the screw
holes on each side of
the charger. Attach the
handle, using the
four 8-32 x 1"
pan head
screws
provided.
NOTE: During charging, the display will
go into sleep mode and will not show the
amperage of the battery. To turn the display
back on, press the DISPLAY button.
DISPLAY BUTTON
Use this button to set the function of the
digital display to one of the following:
• AMPS – The display shows the selected
charge rate, in amps.
• TIME – The display shows the remaining
time during Boost mode.
RATE SELECTION BUTTON
Use this button to select one of the following:
• CHARGE/MAINTAIN 6A<>2A –
For charging small and large batteries. Not
recommended for industrial applications.
• BOOST 40A – For quickly adding
energy to a severely discharged or large
capacity battery prior to ENGINE START.
• ENGINE START 200A – Provides 200
amps for cranking an engine with a
weak or run-down battery. Always use in
combination with a battery.
• 5 •
2
5
5
5