Control Panel - Schumacher Electric CR2 Manual Del Usuario

6.

CONTROL PANEL

LED Display
A.C. POWER
There is AC power supplied to the battery charger.
CHARGING
The charger is charging the battery.
CHARGING
The charger is in abort mode.
CHARGED
The battery is fully charged and the charger is in maintain mode.
7. OPERATING INSTRUCTIONS
Battery Information
This charger can be used with 12, 16 and 24V batteries; it automatically detects your
battery type.
Charging
NOTE: Examine the battery for excessive wear, cracks, bulging or damage each time you
charge it. If damage is detected, do not charge the battery, replace it immediately. If the
battery is hot, allow it to cool before charging.
1. Connect the battery following the ride-on toy's instruction manual.
2. Connect the AC power following the precautions listed in section 3.
3. If you've connected everything correctly, the CHARGING
indicating that the charger is charging.
Using the Quick Cable XLR Connector
1. Connect the output cable assembly to the charger. Make sure to place the charger
on a dry, non-flammable surface, such as wood or concrete.
2. With the charger disconnected from the wall outlet, connect the supplied harness
assembly by connecting the yellow connector to the yellow connector on the end of
the charger cable. Connect the other end of the cable assembly to the battery.
NOTE: See Replacement Parts for more connector information.
NOTE: Never connect the output cable assemblies together for use in other applications,
such as external battery or other power source charging, or to extend the output cable
length, as reverse polarity and/or overcharge conditions will occur.
Complete Charge
When the CHARGING
is completely charged and the charger has switched to the Maintain Mode of operation.
When ready to use, unplug the charger from the wall outlet and then disconnect the
charger from the battery.
NOTE: For longer battery life, the battery must be completely charged after two
consecutive quick charges. (Example: quick-quick-complete.)
Aborted Charge
If charging can not be completed normally, charging will abort. When charging aborts, the
charger's output is shut off, and the CHARGING
charge, unplug the charger from the AC outlet, wait a few moments and plug it back in.
(red) LED lit:
(yellow) LED lit:
(yellow) LED flashing:
(green) LED lit:
This battery charger must be properly assembled in accordance with the
assembly instructions before it is used.
This charger does not have an ON/OFF switch. ON and OFF are
controlled by plugging in the charger to the AC wall outlet.
LED turns off and the CHARGED
LED will blink. To reset after an aborted
4
• •
LED should be lit,
LED is lit, the battery