Cembre HT51D Manual De Uso Y Mantenimiento página 5

Remove the handle restraint (5) to release the moveable handle (7).
Insert the conductor into the connector (Ref. to Fig. 2).
Position the connector between the dies and ensure the correct location of the crimp
(Ref. to Fig. 3).
NOTE: when more compression
is required, proceed according
to the sequence and direction
indicated in the fi gure.
Ensure that the latch and the upper die holder are fully secured, otherwise damage
may occur during tool operation.
2.2) Die advancement
Operate moveable handle (7) for die advancement. This fi rst stage rapidly closes the dies
to the connector (the automatic opening of the moveable handle allows the operation
of the tool using one hand, while locating the connector in the desired crimp position
with the other).
Make sure that dies are exactly positioned on desired crimp point;
otherwise re-open dies following instructions as per § 2.4 and reposition the con-
nector.
2.3) Crimping
Continue to operate the moveable handle (7).
The tool will automatically change over to the high pressure stage and the ram will
advance until the dies meet.
It is recommended to continue pumping until the maximum pressure valve is activated
and a "click" is heard.
2.4) Die re-opening
Press the pressure release lever (3) for the rapid retraction of the ram and subsequent
die re-opening, releasing the crimped connector.
5
terminal
2 3
1
3
1 2
1
2
3
connector