Leveling - Fulgor Milano FD6W24FI1 Instrucciones De Instalación

EN
• If the appliance is not in a niche and can therefore be accessed on one
side, cover the door hinge area for safety reasons (cutting hazard). Covers
are available as accessories from specialized retailers or from the Technical
Service Centre.
• To build in the dishwasher, purchase the relative kit from specialized retail-
ers or from the Technical Service Centre.
5.1
5.1.2 Levelling the appliance
Level the appliance using the relative adjustable feet (e.g.: ref. A fi g. 5-01); use
an open-ended wrench to rotate the feet until the dishwasher is perfectly level.
Some models are fi tted with just one rear foot which can be adjusted with a
screw located at the bottom front of the appliance (ref. A fi g. 5-02); use a suit-
able Phillips screwdriver or 8 mm hex head bushing to turn the screw until the
dishwasher is perfectly level.
Use a spirit level to check the appliance is perfectly level (ref. B fi g. 5-01).
Leveling is vital for assuring correct dishwasher operation.
Make sure to leave a gap of at least 3 mm (7/64") between the top of the dish-
washer and the worktop (ref. C fi g. 5-01).
12
INSTALLATION INSTRUCTION

Leveling

Fig. 5-01