How To Assemble Your Light Kit - Fanimation KINDRED LP8543LGR Manual Del Usuario

CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
1. Remove one of the three screws in the adaptor
plate at the bottom of the motor assembly and retain
the screw for later. Slightly loosen the remaining two
screws. (Figure 1)
2. Assemble the light plate assembly to the adaptor
plate of the motor assembly using the two key slots
in the light plate assembly. Replace the third screw
and secure all three screws. (Figure 2)
3. Remove one of the three screws in the light plate
assembly and retain the screw for later. Slightly
loosen the remaining two screws. (Figure 3)
4. Connect the 2 single pin connectors from the light
kit assembly to the 2 single pin connectors from motor
assembly. (Figure 4)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.

How to Assemble Your Light Kit

Light Plate
Assembly
Light Kit
Assembly
14
Motor Assembly
Figure 1
Figure 2
Figure 3
Motor
Figure 4
Light Plate
Assembly