How To Assemble Your Light Kit Assembly Or Cap - Fanimation ODYN 84 Manual Del Usuario

How to Assemble Your Light Kit Assembly or Cap

1. Remove the six screws in the support bracket
at the bottom of the motor assembly. Assemble
the light plate assembly to the support bracket
using the previously removed screws. (Figure 1)
2. Remove the three screws in the light plate
assembly. Assemble the light kit assembly to the
light plate assembly using the previously removed
screws. (Figure 2)
3. (Option A--for use with light kit)
Remove the three screws in light kit assembly and
retain for Step 4. Connect the 2 pin connectors
from the LED assembly to the 2 pin connectors
from motor assembly. (Figure 3A)
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
NOTE: If you have installed your fan with the steel cap,
skip steps 4 and 5.
4. Assemble the LED assembly to the light kit assembly
using the screws removed in Step 3A. (Figure 4)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
5. Secure the glass to light kit assembly by twisting
in a clockwise direction. Do not over-tighten. (Figure 5)
All manuals and user guides at all-guides.com
Light Kit
Assembly
Light Kit
Assembly
LED Assembly
12
Figure 1
Figure 2
Motor
Light Kit
Assembly
Steel Cap
Figure 3A
LED Assembly
Figure 4
Glass
Figure 5
Light Plate
Assembly
Light Plate
Assembly
Figure 3B