Operating Yourwine Cooler - Avintage AV24XI-1 Manual De Utilización

Remove the glass door by unscrewing the eight lock screws 3 and 4. Be careful to hold the glass door firmly after removing
the screws and place it on a padded surface to avoid the risk of damage.
Unscrew and transfer the door supporter 2 to the opposite side.
Rotate the glass door 180° and refit the glass door to the opposite side. Then screw and tighten it after the door is leveled.

OPERATING YOURWINE COOLER

The Wine Cooler should be placed in a position where the ambient temperature is between 16-38°C/60~100ºF. If the
ambient temperature is above or below this range, the performance of the unit may be affected. For example, placing your
unit in extreme cold or hot conditions may cause interior temperatures to fluctuate. The range of 5-22°C/40-72ºF may not be
reached.
Note:
When you use the Wine Cooler for the first time or restart the Wine Cooler after having been shut off for a long time, there could be
a few degrees variance between the temperature you select and the one indicated on the LED readout. This is normal and it is due to
the length of the activation time. Once the Wine Cooler is running for a few hours everything will be back to normal.
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart
before this time delay, the Wine Cooler will not start.
THE CONTROLS OF YOUR WINE CELLAR
MODEL 1 ZONE
Power
To turn this appliance on/off, press the bottom
the audible alarm when the alarm is on.
LIGHT
To control the inner light turn on/off.
« UP »
Used to increase (warm) the set temperature by 1°C/1°F.
« DOWN »
Used to decrease (cool) the set temperature by 1°C/1°F.
SELECTOR
Select the temperature display setting in Fahrenheit or Celsius degree. To change the temperature from Fahrenheit to
Celsius or from Celsius to Fahrenheit, press the button
and hold for 5 seconds. Pressing the
for 5 seconds
key once can switch off
39