Ebode TAKE 6IR+RF Guia Del Usuario página 10

6. Depending on the type of remote control you have,
you can use one of two methods:
a. Press the button on the existing remote control you
want to learn. Keep this button pressed until the LED on
the TAKE 6 Remote extinguishes. If the LED does not
extinguish, but starts flashing, you need to use method B.
(If youhave just tried method A and want to try method B,
first repeat step 5).
b. Press the button on the existing remote control you
want to learn. Keep this button pressed as long as you
would when using the original remote control.
7. Repeat steps 5 and 6 for every button you want to
learn.
8. When you have finished learning the buttons, press
SETUP (8)
Erasing the commands learned per mode to clear
memory space
You can erase the commands learned and saved for
each separate function (TV, VCR, etc.):
1. Keep the SETUP (8) button pressed until the LED stays lit.
Release the SETUP (8) button.
2. Press the Mode button of your choice (TV, DVR, etc.).
The LED will flash once.
3. Press the LEARN (20) button twice.
4. Press SETUP (8). The LED will extinguish after a few
seconds.
5. All commands learned and saved for the selected
function have now been erased.
4.6. Identifying codes found
If you don't know the code (for example because you
found the code by autosearch) you can identify it as
described below:
1. Press and hold S (8) until the LED indicator (2) lights
steadily. Release S.
2. Press the mode key (4) for the equipment you want to
identify (DVR, DVD, STB, AUDIO or AUX). The LED blinks
once.
3. Press again S. The LED blinks once.
4. To identify the first digit press each number button from
0 - 9 (14) until the LED blinks. The number you pressed is
the first digit of the code.
5. Press each number key from 0 - 9 as above to find the
second digit.
6. Press each number key from 0 - 9 as above to find the
third digit.
7. Press each number key from 0 - 9 as above to find the
fourth digit. When the fourth digit has been found the LED
will go off.
4.7 Volume Control Punch Through
The TAKE 6 remote control allows you to select which
Mode controls your volume/mute buttons. The volume
buttons (5) and Mute (3) can be set for individual control
by EACH device Mode or can be set for ALL device
Modes to punch-through volume control to one specific
single device Mode. The remote is initially set (Factory
Default) for control by each specific device Mode.
Adjustment of ALL volume controls to one mode.
You can allocate volume control to one of the modes of
the remote control providing that volume control exists on
13-3-2014 10 ebode TAKE6 IR/RF