Harbor Breeze 40087 Manual De Instrucciones página 11

STANDARD OR ANGLE MOUNTING INSTRUCTIONS
7. Depending on the length of the downrod you use,
you may need to cut the lead wires back to simplify
the wiring. If you decide to cut back the lead wires,
it is suggested you do so in the following manner:
Take the lead wires and make sure you have pulled
them all the way through the top of the downrod and
measure 8 in. of lead wire. Then cut the excess wire
off with wire cutters (not included).
8. If you decided to cut back the lead wire in Step 7,
strip 1/2 in. of insulation from the end of the white
wire. Twist the stripped ends of each strand of wire
within the insulation with pliers. Repeat this step for
black, blue (if applicable) and green wires.

Important: If you did not cut back the lead wires in
Step 7, Step 8 is not necessary and you
may proceed to Step 9.
9. While pressing the corresponding wire button on the
downrod (A), insert the stripped end of the black wire
from downrod (A) into the hole, then release the wire
button. Gently pull the wire to be sure it is secure.
Repeat for the remaining wires.
7
8
9
Wire
Button
Lowes.com/harborbreeze
11
Green
White
Blue
A
Black