Changing The Presser Foot - Singer 2263 Manual De Instrucciones

START SEWING
2 3

Changing the Presser Foot

⚠
Turn machine off before changing the presser foot.
Before changing the presser foot, raise the presser foot lifter.
The presser foot holder (b) is attached to the presser bar (a). The presser foot (f) has a presser
foot pin (d) that connects to the presser foot holder, sometimes called a shank (b). The shank has a
groove (c) on its underside, which connects it to the presser foot.
To remove a presser foot from the shank, press the lever (e) at the back of the shank. The foot will
release. To attach a presser foot to the shank, line up the presser foot pin (d) underneath the groove
(c) on the shank (b). Lower the presser foot lifter, bringing the shank's groove down over the pin. The
foot will snap on.
Some optional presser feet require you to remove the shank from the machine. To remove the shank
from the machine (see below) loosen and remove the screw that holds the presser foot onto the
presser bar (a), then remove the shank (b). To replace the shank, set the shank onto the presser bar,
then replace the screw.
This machine has a low shank with snap-on presser feet. When shopping for optional presser
feet and attachments for your machine, look for low-shank, snap-on style.
26