Changing The Presser Foot; Sew Easy Foot - Singer 3337 Manual De Instrucciones

2
3
START SEWING

Changing the Presser Foot

⚠
For safety, turn off the power before changing the presser foot.
Before changing the presser foot, raise the presser foot lifter.
The presser foot holder (b) is attached to the presser bar (a). The presser foot (e) has a presser foot
pin (d) that connects to the presser foot holder, sometimes called a shank (b). The shank has a groove
(c) on its front, which connects it to the presser foot.
To remove a presser foot from the shank, pull the presser foot (e) toward you to disengage from the
groove (c). The foot will release. To attach a presser foot, slide the pin (d) of the presser foot (e) into the
groove (c) on the shank. The foot will snap on.
Some optional presser feet require you to remove the shank from the machine. To remove the shank
from the machine (see above) loosen and remove the screw that holds the presser foot onto the
presser bar (a), then remove the shank (b). To replace the shank, set the shank onto the presser bar,
then replace the screw.

This machine has a low shank with snap-on presser feet. When shopping for optional presser feet
and attachments for your machine, look for low-shank, snap-on style.

Sew Easy Foot

e
THIS BONUS ITEM IS NOT INCLUDED WITH MACHINES SOLD IN SOME AREAS AND MAY BE
AN OPTIONAL ACCESSORY. FOR INFORMATION ON PURCHASING THIS ITEM, GO TO WWW.
SINGER.COM.
j
The Sew Easy Foot has a guide to help you sew the most accurate seams every time. The foot has an
extension marked with the most popular seam allowances and a movable fabric guide that can be set
wherever you want for the project you are making.
1. Attach the Sew Easy Foot.
2. Select Straight Stitch.
o
3. With your needle set in the center position, use the guide to select 3/8", 1/2", 5/8", 3/4", and even 1"
seam allowances.
4. Place your fabric under the foot, lining up the raw edges with the guide on the foot. Lower the
presser foot lifter, then sew.
26