Klarstein 10029385 Manual De Instrucciones página 22

EN
22
3
Sliding the chimney to adjust the chimney
height. When the height you required is
reached, then fix 2 pcs of 4x8mm screws
onto the hole fixing with plate (see
arrow) as showed in picture.
Installation (Vent inside)
If you do not have an outlet to the outside, exhaust pipe is not required and the
installation is similar to the one show in section "Installation (Vent outside)".
4
Drill 2 x 8mm holes to accommodate
the plate (see arrow). Screw and tighten
the plate II onto the wall with 2 screws
provided. Assemble the chimney onto the
unit and fix it with 2 screws.
5
Use 2pcs 4 x 8 mm screws to attach
lower and upper chimney together,
do not fasten screws too much, make
sure upper decorative chimney can be
telescopically adjusted after assembled.
(A) Upper chimney
(B) Lower chimney attachment
(C) Lower chimney