Functional Description; Removing/Inserting The Battery - Milwaukee M18 FUEL Manual Del Operador

SPECIFICATIONS
Volts.............................................................. 18 DC
Battery Type .................................................M18™
Charger Type................................................M18™
Cat. No. ..................................................... 2744-20
Collation Angle................................................... 21°
Fastener Length .....................................2" – 3-1/2"
Fastener Size (Diameter) .................... 0.113" - 0.148"
Magazine Capacity ......................................... 43 nails
Cat. No. ..................................................... 2745-20
Collation Angle................................................... 30°
Fastener Length .....................................2" – 3-1/2"
Fastener Size (Diameter) .................... 0.113" - 0.131"
Magazine Capacity ......................................... 51 nails
Recommended Ambient
Operating Temperature ......................0°F to 125°F

FUNCTIONAL DESCRIPTION

1
14
11
12
13
1. Trigger
2. Handle
3. Power/Actuation
selection
4. Belt hook
5. Rafter hook
6. Hex wrench
(backside of tool)
7. Nail slot
Cat. No.
3
4 2744-20
2
5
9
10
15
8. LED (backside of tool)
9. Magazine
10. Nail pusher
11. Pusher release button
12. Striker
13. Workpiece contact
bracket
14. Depth adjustment
15. No-Mar pad
WARNING
cific charging instructions, read the operator's
manual supplied with your charger and battery.

Removing/Inserting the Battery

To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
ries.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
The No-Mar pad on the nose of the tool protects
the workpiece when the workpiece contact is com-
pressed during actuation.
1. Remove the battery pack.
2. Snap the No-Mar pad into place over the points
of the workpiece contact bracket.
3. Pull on the No-Mar pad to be certain it is properly
secured.
7
4. To remove the pad, pull the pad away from the
workpiece contact bracket.
6
Installing/Removing Fastener Strips
WARNING
Always wear safety goggles or glasses with side
shields.
Keep fingers clear of fastener track of magazine.
Pusher could pinch fingers, causing injury.
8
To install fastener strips:
1. Remove battery pack.
2. WARNING! Always point the tool away from your-
self and others when installing fasteners. Failure
to do so could result in injury.
3. Slide the fastener strip into the nail slot and down
toward the front of the tool. Be sure the point of the
fasteners is pointed downward. WARNING! Use
only recommended fasteners of the correct size,
length, collation angle and head type as indicated
on the tool's nameplate. Other fasteners could
result in tool malfunction, leading to injury.
4. Press and hold the pusher release button and slide
the pusher back past the end of the fastener strips.
5. Continue to hold the pusher, but release the but-
ton. Slowly slide the pusher forward until it rests
against the fastener strip.
To remove fastener strips:
1. Remove battery pack.
2. WARNING! Always point the tool away from your-
self and others when installing fasteners. Failure
to do so could result in injury.
3. Press and hold the pusher release button and slide
the pusher towards the front of the tool. Release
the pusher.
4. Slide the nails back and out of the nail slot.
4
ASSEMBLY
Recharge only with the charger
specified for the battery. For spe-
Always remove battery pack before
changing or removing accesso-
Attaching No-Mar Pad
Always remove battery pack before
changing or removing fasteners.