Commissioning The Appliance; Attaching The Covers; Adjusting The Door Opening Angle (Refrigerator Compartment Door) - Bosch B36IT71SNS Instrucciones De Instalación

16. Commissioning the appliance

m
CAUTION
Check that the finger guard functions. In particular check
– that the finger guard is correctly attached to the
appliance and
– that the finger guard slides smoothly forwards and
backwards when the refrigerator compartment
doors open and close.
To guarantee the accuracy of the following working steps
and thus the appearance of the overall kitchen front later on,
the appliance should now be operated.
Open the appliance door.
Press the POWER button.
Only for appliances with a water connection:
NOTE
In order to avoid the risk of damage caused by leaking
water from damage possibly caused to the water pipe
feeding the appliance, keep the shut-off valve closed.

17. Attaching the covers

Press cover strips on the handle sides of the doors into
the gap between stainless steel front and appliance
door.
Press cover strips on the freezer compartment drawer
into the gap between stainless steel front and drawer.
m
Insert the cover plate on the freezer compartment door.
18. Adjusting the door opening angle
(refrigerator compartment door)
Depending on the installation situation, it may be necessary
to adjust the door opening angle. A door opening angle of
115° has been set at the factory.
To adjust the door opening angle to 90°:
Open the door to 90°.
Insert the banking pin through the boreholes which are
now vertically aligned and drive in with a hammer.
21