Warnings; Before Installation - Toto EcoPower Manual De Instrucciones

Please read and adhere to these notes. Failure to do so could
result in personal injury and/or property damage.
Never splash water on the controller. The EcoPower Flush Valve is an electric appliance.
Risk of product malfunction.
Do not strike or kick the EcoPower Flush Valve. Risk of product malfunction or water leakage.
Do not use the EcoPower Flush Valve at temperatures exceeding what local codes or
product specification allow. Risk of product malfunction.
Do not place an item in a room with high humidity such as shower area or sauna. Risk of
product malfunction.
Never attempt to disassemble, reassemble, repair or modify the EcoPower Flush Valve
unless you are a professional. Risk of product malfunction and electric shock.
Do not use standard vacuum breaker or control stop with reclaimed water flush valve.
Do not use petroleum based products or pipe sealants, doing so could damage product and
cause water damage.
IMPORTANT: Plumbing installation must be in accordance with applicable codes and
regulations. Water supply lines must be sized to provide an adequate volume of water for
each fixture. Flush all waterlines prior to operation.
Toilet and urinal Flush Valves are not interchangeable, check the model number on the label to
make sure you have the correct type. Toilet Flush Valve model numbers begin with 'TET' and
Urinal Flush Valve model numbers begin with 'TEU'.
Prior to installing your Flush Valve, install the items listed below:
Bowl fixture/Urinal fixture
Drain line
Water supply line
The supply piping to these devices must be securely anchored to the building structure to
prevent the installed device moving during use. Prevent marring to the exposed surface
during installation. IMPORTANT: Purge all air from the supply lines before connecting
flush valve to the bowl. Trapped air in supply lines may crack the china.
Except for TET6GAR, TET6UA(R)(X) and TET6LA(R)(X), install the Flush Valve so the control
stop is no less than 11-1/8" (282mm) above the top of the bowl/urinal. For TET6GAR,
TET6UA(R)(X) and TET6LA(R)(X), install the Flush Valve such the control stop is 27" (685.8mm)
above the bowl/urinal. see local codes for special requirements.
Avoid damaging the surface of the infrared sensor while unpacking.
For Toilet Flush Valve:
The toilet Flush Valve may not function if toilet seat or lid cover are left upright and block the
sensor.
For Urinal Flush Valve:
The urinal Flush Valve is designed for optimal performance with a washout urinal, but a
siphon jet urinal may be substituted. Blowout urinals are not recommended.
For Reclaimed Water Flush Valve:
Only use reclaimed water angle stop and vacuum breaker.
The detection range of the infrared sensor is shown on p.15.
To prevent valve malfunction, do not install a handrail or any other object within the detection
range of the sensor. Do not install the Flush Valve where sensor faces a mirror, stainless steel
wall, other highly reflective surfaces or another infrared sensor.

WARNINGS

BEFORE INSTALLATION

6