Inserting A Smart Card - Pioneer KURO KRL-37V Manual De Instrucciones

Connecting external devices

Inserting a smart card

In order to receive coded digital stations, a Common
Interface Module (CA Module) and a smart card must
be inserted in the Common Interface slot of the TV
(Page 14).
The CA Module and the smart card are not supplied
accessories. They are usually available from your
dealers.
Inserting the smart card into the CA Module
1
With the side with the gold coloured contact
chip facing the side of the CA Module marked
with the provider's logo, push the smart card
into the CA Module as far as it will go. Note the
direction of the arrow printed on the smart card.
Inserting the CA Module in the Common
Interface slot
2
Carefully insert the CA
Module in the Common
Interface slot with the
contact side forward. The
logo on the CA Module
must be facing forward
from the rear of the TV.
Do not use excessive
force. Make sure the
module is not bent in the
process.
Checking CA Module information
NOTE
• Make sure that the CA Module is properly inserted.
• This menu is only available for digital stations.
1
Press h and the "HOME MENU" screen
displays.
2
Press a/b to select "Digital Setup".
• The content of this menu depends on the provider of
the CA Module.
3
Press a/b to select "CI Menu", and then press
ENTER.
E
Module
General information on CA Module displays.
E
Menu
Adjustment parameters of each smart card
displays.
E
Enquiry
You can input numerical values such as passwords
here.
NOTE
• The content of each screen depends on the provider of
the CA Module.
Removing the CA Module
1
Remove the cover from the rear of
the TV.
2
Remove the module from the TV.
3
Replace the cover.
25