Pioneer KURO KRL-37V Manual De Instrucciones página 46

Appendix
Troubleshooting
Problem
• No power.
• The TV cannot be operated.
• Remote control unit does not operate.
• Picture is cut off.
• Strange colour, light colour, or dark
colour, or colour misalignment.
• Power is suddenly turned off.
• No picture.
• No sound.
• The TV sometimes makes a cracking
sound.
Cautions regarding use in high and low temperature environments
• When the TV is used in a low temperature space (e.g. room, office), the picture may leave trails or appear slightly delayed.
This is not a malfunction, and the TV will recover when the temperature returns to normal.
• Do not leave the TV in a hot or cold location. Also, do not leave the TV in a location exposed to direct sunlight or near a
heater, as this may cause the cabinet to deform and the LCD panel to malfunction.
Storage temperature: e5 °C to e35 °C.
Information on the software license for this product
Software composition
The software included in this product is comprised of various software components whose individual copyrights are held by
Pioneer or by third parties.
Software developed by Pioneer and open source software
The copyrights for the software components and various relevant documents included with this product that were developed
or written by Pioneer are owned by Pioneer and are protected by the Copyright Act, international treaties, and other relevant
laws. This product also makes use of freely distributed software and software components whose copyrights are held by
third parties. These include software components covered by a GNU General Public License (hereafter GPL), a GNU Lesser
General Public License (hereafter LGPL) or other license agreement.
Obtaining source code
Some of the open source software licensors require the distributor to provide the source code with the executable software
components. GPL and LGPL include similar requirements. For information on obtaining the source code for the open source
software and for obtaining the GPL, LGPL, and other license agreement information, contact your local Pioneer Customer Service.
We are unable to answer any questions about the source code for the open source software. The source code for the
software components whose copyrights are held by Pioneer is not distributed.
Acknowledgements
The following open source software components are included in this product:
• linux kernel • modutils • glibc • zlib • libpng
Check if you pressed a (TV) on the remote control unit.
•
If the indicator on the TV lights up red, press a (TV).
• Is the AC cord disconnected?
Check if you pressed a on the TV.
•
• External influences such as lightning, static electricity, etc., may cause improper operation. In this
case, operate the TV after first turning off the power, or unplugging the AC cord and re-plugging
it in after one or two minutes.
Are batteries inserted with polarity (e, f) aligned?
•
• Are batteries worn out? (Replace with new batteries.)
• Are you using it under strong or fluorescent lighting?
• Is a fluorescent light illuminating to the remote control sensor?
• Is the image position correct?
• Are screen mode adjustments (SCREEN SIZE) such as picture size made correctly? (Pages 35
and 39)
• Adjust the picture tone.
• Is the room too bright? The picture may look dark in a room that is too bright.
• Check the "Colour System" setting (Pages 33 and 38).
• The TV's internal temperature has increased.
Remove any objects blocking the vent or clean.
• Is the "Sleep Timer" set? Select "Off" from the "Sleep Timer" menu (Page 32).
• Is "No Signal Off" or "Ecology" activated?
• Are connections to external equipment correct? (Pages 21–23)
• Is the input signal type selected correctly after connection? (Page 38)
• Is the correct input source selected? (Page 16)
• Is a non-compatible signal being input? (Page 42)
• Is the picture adjustment correct? (Pages 30–31)
• Is the antenna connected properly? (Page 14)
• Is "On" selected in "Audio Only"? (Page 36)
• Is the volume too low?
• Make sure that headphones are not connected.
Check if you pressed e on the remote control unit.
•
• This is not a malfunction. This happens when the cabinet slightly expands and contracts
according to changes in temperature. This does not affect the TV's performance.
Possible Solution
43