Tabla de contenido
Publicidad
Do not place the appliance on soft, unstable surface or cover it with a cloth while in operation as it may cause overheating or breakdown.
Keep away from children.
Do not leave the meat grinder switched on when you do not use it.
Do not use other attachments than those supplied.
Do not overload the appliance.
Keep the cord away from sharp edges and hot surfaces.
Do not place the appliance near gas or electric oven or store at heated surface.
The blades are very sharp, so handle them with care.
Do not push products into the appliance by fingers while it is in use.
If food becomes lodged in feeding tube, use pusher to push it down. If this doesn‟t work, turn the motor off, unplug the appliance and disassemble it to remove remaining food.
Do not carry the unit by the food tray or head. Be sure to hold the housing with both hands.
Do not fix the cutting blade and cutting plate while using sausage and kebbe attachments.
Do not operate after malfunction or damage of cord.
Do not grind hard food, such as bones, nuts, ginger or other products with hard fiber.
Do not operate for more than 10minutes at one time. Turn off switch and let it rest for at least 15 minutes to cool down the motor, otherwise the motor may be damaged.
If in case of overloading the overheat protection system is activated, switch off the appliance by pressing the button REV/OFF, unplug it, and let the appliance cool down about 20-30 minutes, and then
continue operation.
Do not attempt to repair, adjust or replace parts in the meat grinder. Repair the malfunctioning appliance in the nearest service center.
The grinder head may rotate slightly during the use, but it is normal.
Do not over tighten the fixing ring to stop the movement. It may cause damage.
Removable metal parts (screw, cutting knife, cutting plates) can be oxidized after use. It is normal.
BEFORE FIRST USE
Unpack your appliance. Remove all packing materials.
Check if all parts are in a set and not damaged.
Clean all the parts according to the article «Cleaning and maintenance». Do not immerse motor unit into water.
Dry thoroughly before use.
USING THE APPLIANCE
ASSEMBLING
11
Publicidad
Tabla de contenido
