LG WT7005C Serie El Manual Del Propietario página 15

us_main.book.book Page 15 Tuesday, November 17, 2020 10:53 AM
• Connect this appliance to a grounded outlet
conforming to the rating prior to use. Failure to
do so may result in fire, electric shock, or
malfunction.
• Do not damage or cut off the ground prong of
the power cord. Doing so may cause death, fire,
electric shock, or product malfunction.
• Improper connection of the equipment-
grounding conductor can result in risk of electric
shock. Check with a qualified electrician or
service technician if you are in doubt as to
whether the appliance is properly grounded. If it
does not fit the outlet, have a proper outlet
installed by a qualified electrician.
• The appliance and outlet must be positioned so
that the plug is easily accessible.
• Do not use adapter or extension cords. Doing so
may result in serious injury, fire, electric shock,
or death.
• For best performance, plug the appliance into its
own individual outlet. This helps prevent
overloading house wiring circuits which could
cause a fire hazard from overheated wires.
• If necessary, use a new, UL-listed 3-prong
(grounding) plug rated at no less than the
branch circuit. Do not use an extension cord
longer than 3 feet. Failure to follow these
warnings may result in serious injury, fire,
electric shock, or death.
Testing the Washer
Check if the washer is properly installed and run a
test cycle.
1
Make sure that the tub is empty. Do not load
anything in the tub for this test.
2
Press the Power button.
3
Press and hold the Spin and Soil buttons
simultaneously until an
the display.
• is displayed first, and
1N
displayed.
• : Initial test
1N s
• : Previous test result was good.
1N sO
• : Previous test ended with an error.
1N sE
• The indication is different for each model.
4
5
6
Installation Check Error Codes
Refer to the chart below before calling for service.
code appears in
1N s
, , or is
s sO sE
Press the Start/Pause button.
• The test will run for about 3 minutes.
• The test automatically checks the water
inlet hoses and the drain hose.
Check the display for results.
At the end of the test cycle,
display. The washer will shut off automatically
after a short delay.
Error Code
• Fully open the water faucet.
IE
• Straighten out any kinks in the
inlet hoses and make sure the
hoses are not pinched against
the wall or under the washer.
• Straighten out any kinks in the
OE
drain hose and make sure the
hose is not pinched against the
wall or under the washer.
• Remove and flush out the drain
hose to remove clogs.
• Adjust or repair the drain.
Maximum drain height is 96
inches.
INSTALLATION 15
or will
ENd O
Solution