Promax SATHUNTER+ Manual De Instrucciones página 55

USER'S MANUAL. SATHUNTER+.
Note: We advise to assign two test points to each satellite, the first one with
vertical polarization and the second one with horizontal polarization in
order to guarantee the identification of the satellite.
The key [2] enables you, as you can see at figure 11, to change the selected
test point in a sequential way. Each time you press shortly this key it advances to the
next test point. If you press longer (1 s.) this key it goes back to the previous test point.
If you want to go to the first test point (TP1) you should press the key
When you select a satellite test point, the name (four letters maximum) and
frequency assigned to that point is displayed.
Afterwards, if it is detected a signal with a valid transport stream at the frequency
(or frequencies) assigned to this satellite, the instrument will show at the top right corner
the symbols DVB-S,
transport stream. Additionally it will attempt to obtain, the Network, the first 48 services
and the orbital position of the satellite the antenna is pointing at. When this information is
detected, it will be shown on the display. Sometimes this could cause a reduction in the
amount of identifying text characters.
NOTE: For DSS, the TS information is not available.
10/2010
Figure 11.- Rotation of active test points.
Figure 12.- Satellite identification screen.
DVB-S2 or
[1] for 1 s.
DSS depending on the selected
Page 19