Antenna Adjustment For Optimum Signal Quality (3> Adjust) - Promax SATHUNTER+ Manual De Instrucciones

The signal provider is the exclusive responsible in the accuracy of the orbital
position. PROMAX ELECTRONICA, S.A. only extracts and shows the information
contained in the detected signal.
At first, it could be that the equipment could not detect a signal with a valid
transport stream and therefore it will appear the
right corner and the name of the test point memorised. If later on, the equipment
achieves to synchronize, it will update the services list and the colour of the symbol
shown will change to
4.3.3 Antenna Adjustment for Optimum Signal Quality (3> ADJUST)
Once the antenna has been positioned in order to receive the maximum power
and you have checked that the antenna is pointing the right satellite, the antenna and
the LNB have to be adjusted to achieve the maximum MER level, and therefore the best
quality at reception.
The adjustment (ADJUST) function shows the information regarding the signal
quality. You should select the 3> ADJUST function pressing the key
detects a signal with a valid transport stream, the SATHUNTER + shows briefly the
network name and orbital position at the top line of the screen. When it is locked to the
signal, it shows the symbol
detected. This function measures the ratio between the DVB average power and the
noise average in a constellation (MER). It also measures the error rate in a DVB signal,
before the correction process (CBER). Once all the measurements are done
(approximately after 5 s), they will be displayed on the screen in a graphical and
alphanumerical way (see figure 13). At the top line of the screen it keeps displaying the
battery level, the measured LNB voltage and whether the 22 kHz signal is present or
not.
Page 20
, or .
, or
Figure 13.- Adjust function screen.
USER'S MANUAL. SATHUNTER+.
ATTENTION
, or symbol at the top
depending on the satellite signal
[3]. When it
10/2010