Assembly - Greencut GLM660X Manual De Instrucciones

ASSEMBLY

ATTENTION: The lawn mower is supplied without fuel and oil in the engine. Your new lawn mower
has been tested at the production site which means that the engine can contain a small amount
of residual oil.
ASSEMBLY OF THE HANDLEBAR
1. Remove the screws (3a) from the lower handlebar (3) and keep them handy (Fig. 1).
2. Insert the lower bars (3) into the cover brackets (7) up to the end. Make sure that the mounting holes of the
lower bars are aligned with those of the brackets (Fig. 2).
3a
Figure 1
3. Secure the lower links (3) with the screws (3a) and washers (3b). Then tighten the screws (3a) with a Phillips
screwdriver (Fig. 3).
4.
3
3b
3a
Figure 3
3
7
Figure 2
3
79
EN