Sylvania LC200SL9 A Manual Del Usuario página 25

C. Change Password C. Change Password
Although the default code "0000" is supplied with the unit, you can set
your own password.
4
Use [Cursor K /L] to select "CHANGE PASSWORD", then
press [ENTER].
or
5
Press [the Number buttons] on the remote control to
enter the new 4-digit password.
• Enter password again in "CONFIRM PASSWORD"
space.
6
Press [SETUP] to exit.
Note:
• Make sure new password and confirm password must be
exactly the same. If they are different, the space is cleared
for reentering.
• Your password will be erased and return to the default
(0000) when a power failure occurs. If you forget the
password, unplug the power cord for 10 seconds to restore
the password to 0000.
e.g.) digital TV mode
- V - CHIP SETUP -
TV RATING
MPAA RATING
DOWNLOADABLE RATING
CHANGE PASSWORD
NEW PASSWORD
_ _ _ _
CONFIRM PASSWORD
_ _ _ _
25
EN