Connection; Basic Connection - Sylvania LC200SL9 A Manual Del Usuario

Televisión digital con pantalla lcd de 20 pulgadas
Ocultar thumbs Ver también para LC200SL9 A:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

C
ONNECTION
Cables not included.
Please purchase the necessary cables at your local store.

Basic Connection

This section describes how to connect the unit to an antenna, cable receiver or satellite box.
Note:
• Be sure your antenna or other device is connected properly before plugging in the power cord.
[Antenna Cable Connection]
When connecting the unit to an antenna or cable TV signal (without cable receiver/satellite box)
Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit.
e.g.)
VHF / UHF
antenna
or
cable TV
signal
* Once connections are completed, turn on the unit and begin initial setup.
Channel scanning is necessary for the unit to memorize all available channels in your area.
(Refer to "Initial Setup" on page 11.)
Note:
• If you have any question about the DTV's antenna, visit www.antennaweb.org for further information.
• For your safety and to avoid damage to device, please unplug the RF coaxial cable from the antenna input jack before moving the unit.
• If you use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be more effective than set-
top versions.
• To easily switch your reception source between antenna and cable, install an antenna selector.
• If you connect to the cable system directly, contact the CATV installer.
[Connection to Cable Receiver or Satellite Box]
Use an RCA component video cable to connect the component video input jack of the unit to the component video
output jack of the cable receiver / satellite box.
If you connect to the unit's component video input jack, connect RCA audio cable to the audio L/R jack of VIDEO2.
e.g.)
satellite
dish
or
cable TV signal
including PPV
*
You can also connect this unit to the cable receiver or satellite box other than the component video output jack
because they might have different output jacks.
*
Required cables and connecting methods of the cable receiver / satellite box, or the availability channel for the clear
QAM may differ depending on the cable/satellite provider. For more information, please contact your cable/satellite
provider.
8
EN
RF coaxial cable
ANT IN
RF coaxial
cable
STEREO
PCM
cable receiver / satellite box
rear of this unit
(green)
(blue)
(red)
AUDIO OUT
COMPONENT VIDEO OUT
L
R
Y
Pb/Cb
Pr/Cr
RCA component video cable
RCA audio cable
rear of this unit
VIDEO 2
COMPONENT
AUDIO
Y
Pb
Pr
L
R
VIDEO 1
AUDIO
S-VIDEO
VIDEO
L
R
COAXIAL
(green)
(green)
(green)
(blue)
(blue)
(blue)
(red)
(red)
(red)

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Lc200sl9

Tabla de contenido