Switching Each Mode; Switching Audio Mode - Sylvania LC200SL9 A Manual Del Usuario

Switching Each Mode

You can easily switch with the remote control to the DTV (ATSC) and TV
(NTSC) or to access an external device when they are connected to the unit.
1
Press [INPUT] repeatedly to cycle through input
modes.
• To use the video or S-video input jack on the unit,
select "VIDEO1".
• To use the component video input jack on the unit,
select "VIDEO2".
Note:
• When you switch the analog mode to the digital mode,
it may take a while until the digital channel selection is
completed. The following TV screen is displayed while
switching the mode.
[ANALOG MODE]
[DIGITAL MODE]
[VIDEO1]
[VIDEO2]
NOW SCANNING

Switching Audio Mode

This section describes how to switch the audio in the analog mode and how
to switch the audio language in the digital mode.
TV
While receiving an MTS broadcast, press [AUDIO]
repeatedly to cycle through the available audio
channel.
MAIN : Outputs main-audio
SAP : Outputs second audio program
MONO : Outputs mono-audio
• The information display will automatically disappear
in a few seconds.
DTV
1
Press [AUDIO] to display the currently selected
language and the number of available languages.
2
Press [AUDIO] repeatedly to cycle through the available
audio languages.
• Available languages differ depending on the
broadcast. "OTHER" is displayed when the audio
language cannot be acquired, or the acquired
languages are other than English, Spanish or French.
• The information display will automatically disappear
in a few seconds.
Note:
• Pressing [AUDIO] does not control external audio device.
[MAIN]
[SAP]
[MONO]
KABC CH 95-03
A Day of Memories
ENGLISH 1/3
15
EN