Recommendations For Use - Alfa Pro QUICK Manual De Uso

2. AERATION
The required aeration may be obtained through the implementation of one of the systems described in the
following paragraphs.
2.1 Forced aeration systems
The hourly flow rate of the system must be at least 1,72 m³/h per kW referred to the total rated thermal output of
the installation without compromising the possibility of supplying some fresh air in the room for other purposes
not exclusively related to the safety of the appliance using gaseous fuels. The gas supply must be directed to the
equipment and must be stopped in the event that the air flow rate should fall below the value specified above. In
this case, the gas distribution should be allowed only manually.
2.2 Natural aeration systems
2.2.1 Total rated thermal output not exceeding 15 kW
Through permanent openings facing outwards in the room where the devices are installed. The net area of the
openings or the cross-section must be not less than 100 cm2.
2.2.2 Total rated thermal output not exceeding 35 kW
Through exhaust hoods connected to the flue or duct with natural draft according to the UNI EN 13 384
guidelines.
BEFORE USE
- Remove the protective film from all surfaces, to facilitate removal use hot air (e.g. hair
dryer), do not use sharp tools.
POSITIONING THE OVEN
- To facilitate the handling, we recommend to remove the
bricks placed inside the combustion chamber with the
help of the hemp twine.

RECOMMENDATIONS FOR USE

- Any modification to the device is potentially dangerous.
- Before each use, check that the hose does not have any nicks, cracks, abrasions or cuts. If the hose is
damaged in any way, do not use the oven.
OVEN DOOR
- The oven door is very effective to keep the temperature inside the
oven when the flame is off.
- Never close the door when the flame is lighting.
- Handle the oven doors carefully.
- Do not touch the metal parts of the oven door. Only open using
the appropriate handles.
ELECTRONIC BUTTON
The power button has a AA battery inside, to insert it follow the procedure.
1. Unscrew the head of the button.
2. Insert the battery.
3. Screw the head of the button.
Perform the procedure with the oven off.
- For long periods of disuse, remove the
battery.
EN
15